code continues here Altered code: main.c #include #pragma config ICS = ICS_PGD // Comm Channel Select (Use PGC/EMUC and PGD/EMUD) #pragma config GCP = CODE_PROT_OFF // General Segment Code Protection (Disabled) #pragma config GWRP = GWRP_OFF // General Code Segment Write Protect (Disabled) #pragma config MCLRE = MCLR_DIS // Master Clear Enable (Disabled) #pragma config PWMPIN = RST_IOPIN // PWM Output Pin Reset (Control with PORT/TRIS regs) #pragma config HPOL = PWMxH_ACT_HI // High-side PWM Output Polarity (Active High) #pragma config LPOL = PWMxL_ACT_HI // Low-side PWM Output Polarity (Active High) #pragma config BOREN = PBOR_ON // PBOR Enable (Enabled) #pragma config BODENV = BORV20 // Brown Out Voltage (Reserved) #pragma config FPWRT = PWRT_64 // POR Timer Value (64ms) #pragma config WDT = WDT_OFF // Watchdog Timer (Disabled) #pragma config FWPSA = WDTPSA_512 // WDT Prescaler A (1:512) #pragma config FWPSB = WDTPSB_16 // WDT Prescaler B (1:16) #pragma config FCKSMEN = CSW_FSCM_OFF // Clock Switching and Monitor (Sw Disabled, Mon Disabled)
#pragma config FOS = PRI // Oscillator Source (Primary Oscillator) #pragma config FPR = XT_PLL4 // Primary Oscillator Mode (XT w/PLL 4x) I also moved all configuration bits to a separate header which is only included in the main c source file to avoid future issues. Make: *** Error 255īUILD FAILED (exit value 2, total time: 1s)Īfter some time scratching my head I realised the issue was that configuration bits were being set twice. Applications/microchip/xc16/v1.11/bin/bin/./bin/elf-ld: Link terminated due to previous error(s). Applications/microchip/xc16/v1.11/bin/bin/./bin/elf-ld: Link Error: section. Applications/microchip/xc16/v1.11/bin/bin/./bin/elf-ld: Link Error: region FBORPOR is full (dist/default/production/can_to_ section _FBORPOR) Applications/microchip/xc16/v1.11/bin/bin/./bin/elf-ld: Link Error: region FWDT is full (dist/default/production/can_to_ section _FWDT)
Applications/microchip/xc16/v1.11/bin/bin/./bin/elf-ld: Link Error: region FOSC is full (dist/default/production/can_to_ section _FOSC) While trying to compile some code on MPLAB X I came across this link error, stating that my #pragma config bits were full or sections of them were overlapping other sections.
0 kommentar(er)
